Yokogawa FieldMate - Manual (Page 261)

<I ISA100 device configuration>
I-7
IM 01R01A01-01E 9th Edition : May 31, 2013-00
I-2-4 ISA100 Device Recognition
The followings shows the items displayed in Segment Viewer
Table I-2-3 Display Items in Segment Viewer
Item Contents Default
Update Target Checked items are targets for update or automatic update
-
Update Status Icon “Updating”, “Updated”, or “Failed to update”
Registered Flag
Displays the “!” icon if the device has not yet been registered in
Dvice Maintenance Information
Device Flag Displayed if you set a device flag using the Device Navigator
Memo Flag
Displayed if there is a memo in Device Maintenance
Information.
Basic
Information
Device Tag Device icon or device tag
App.
Device ID (EUI-64) Device specific ID
Address Device IP address
Communication
Status
Indicates whether communication with a device is possible:
“Active”: Communication with the device is possible.
“Inactive”: Preparing to communicate with the device.
Device Role
Represents a device’s role (on the network).
“IO”, “Router”, “IO + Router”
Network ID Network ID for backbone router
Power Supply Status
Power supply feed status
“Battery 100-75%”, “Battery 75-25%”, “Battery 25-0%”,
“Line” (power is fed from the line)
Detail
Information
Status Display*1 Device status
Cond.
Vendor*1 Vendor and its ID
Model*1 Model and its ID
Device Revision*1 Device revision
Basic Information which Default is App. are Gateway incorporated information. Without
accessing ISA100 device, these can be acquired.
Detail information which Default is Cond. requires to access ISA100 devices individually. Turn on
the check box of Update Target.
*
1 : Information defined in gateway YFGW410 are displayed.
The display immediately after the basic information of devices has been acquired is shown
below.
I020401E.ai
2
1
Figure I-2-5 Basic Information