Yokogawa FieldMate - Manual (Page 90)

<E Specifications Common to FieldMate Basic and Advance>
E-40
IM 01R01A01-01E 9th Edition : May 31, 2013-00
 Setting Operations of Function Blocks for FOUNDATION fieldbus H1
Device
After replacing a FOUNDATION fieldbus H1 device, you must check setting of the operations of
built-in function blocks. In some cases, you must internally connect these blocks.
On this window, you can set and connect function blocks built in the FOUNDATION fieldbus H1
device. Operation time and schedule will be automatically set.
And these settings retain in the FOUNDATION fieldbus H1 devices after this operation.
 Startup
Right-click the device on Segment Viewer and select <FF Block Setting>.
E030212E.ai
Click this button to extend the
window for connection settings.
Function blocks in the device are
displayed. Check the desired
checkboxes to set the operation.
Click this button to send the settings displayed
on the window to the device.
Figure E-3-15
E030213E.ai
Select a source block for
connection and its parameter
from the pull-down list.
Select a destination block for
connection and its parameter
from the pull-down list.
Click this button to add the
internal link of function
blocks to the download list.
Send the settings displayed on the
window (operations of function blocks
and download list) to the device.
Click this button to delete the
connection of function blocks
from the download list.
Figure E-3-16