Yokogawa FieldMate - Manual (Page 221)

<F Advance>
F-102
IM 01R01A01-01E 9th Edition : May 31, 2013-00
 DTM Works Detailed Startup Specification
The following table shows the details of the startup states of DTM Works.
Table F-8-1
Startup Source (HMI) Operation DTM Works Startup State
Segment Viewer Built-in
Connection
Device Setup BIC mode
Connected state, Online window
Assigned DTM
Select DTM
User Defined
Connection
New FDT Project UDC mode
Open FDT Project
Assigned DTM
Select DTM
Device Navigator Device Setup BIC mode:
Disconnected state, Offline window
UDC mode:
Device DTM is selected, Disconnected state, Offline
window
Assigned DTM
Select DTM BIC mode:
Disconnected state, Offline window
UDC mode:
Not executable
Open FDT Project UDC mode
Device DTM is selected, Disconnected state, Offline
window
Device Maintenance Info View BIC mode:
Disconnected state, Offline window
UDC mode:
Device DTM is selected, Disconnected state, Offline
window
History Same as with Device Navigator
Note: “Start up DTM Works” in the following description indicates either to start up DTM Works by selecting Action → Device Setup, or
by selecting Action Assigned DTM or Select DTM.
 Select the Connected Device in Segment Viewer and Start up DTM Works in
BIC Mode
1. In the case of PROFIBUS and BRAIN devices, a window is displayed to select the database
device.
2. Starts up DTM Works in the BIC mode.
3. DTM Works displays a window to select the DTM data. (*1)
4. DTM Works displays the DTM Online window in the connected state.
* 1: The selection window appears only when the relevant device is registered to the database and the DTM data is stored in the
device maintenance information. If there is no DTM data, the selection window does not appear and the DTM data is not set. The
process goes to step (4).