Lenze 931E/K Small Drives Control - Manual (Page 11)

Installation
Validity information
3
l
11 SW−HB 13.0002−EN 4.1
3 Installation
3.1 Validity information
The »Small Drives Control« program is used to parameterise the 931E/K servo positioning
controller. The information contained in this Manual refer to the following firmware and
hardware versions:
ƒ 931E servo positioning controller (firmware: version 3.3 or higher)
ƒ 931K servo positioning controller (firmware: version 3.3 or higher)
ƒ »Small Drives Control« parameterisation software (version 2.4 or higher)
The firmware of the 931E/K servo positioning controller and the »Small Drives Control«
parameterisation software must match each other, i.e. if a new firmware version with
additional functions is used, the corresponding version of the Lenze »Small Drives Control«
parameterisation software will be required.
The »Small Drives Control« parameterisation software cannot be used for the
parameterisation of other Lenze controllers.
3.2 System requirements
System requirements for installing the parameterisation program:
ƒ IBM−compatible PC−AT, Pentium II processor or higher with min. 32 MB main
memory capacity and min. 10 MB free hard disk capacity.
ƒ Operating system Windows
®
95, Windows
®
98, Windows NT
®
, Windows 2000,
Windows XP
®
ƒ Free serial interface.
3.3 Software installation
)
Note!
ƒ The current version of the »Small Drives Control« (SDC) software can be
downloaded as installation program from the Lenze web page
(www.Lenze.com).
ƒ The installation is started with the file "Setup.exe".