Lenze 931E/K Small Drives Control - Manual (Page 160)

Appendix
Communication interfaces
Control via the serial interface
10
l
160 SW−HB 13.0002−EN 4.1
Setting the RS232 communication parameters
Select the menu Options W Communication W Baud rate to increase the baud rate to the
Actual data transfer rate:
931e_332
For this, select a Preferred data transfer rate. The program will try to build up
communication with the selected baud rate. The preferred baud rate will be accepted or
reduced to a lower baud rate. The implemented baud rate will be indicated as Actual data
transfer rate.
This baud rate is used for the "standard" online communication with the servo positioning
controller. For the firmware download, a separate baud rate will be selected.
Open the menu Options
W Communication W COM port to select the COM port for
communication between the parameterisation program and the servo positioning
controller:
931e_334