Lenze 931E/K Small Drives Control - Manual (Page 151)

Appendix
Parameterisation of outside motors
Display unit settings
10
l
151 SW−HB 13.0002−EN 4.1
Direct input
Use the Direct input tab to configure the display units. Thus it is possible to use other units
than the display units that are available for selection.
)
Note!
For further information, please see the chapter "Extended options in the menu
display units". (
¶ 152)
(
Stop!
For experienced users only:
In the Direct input tab, the factor group cab be directly written, if the selection
"Direct input" is selected.
The following question appears when the menu is exited:
931e_304
)
Note!
The input limits are automatically adapted to the physical units set. To be on
the safe side, you can check them once again. For this, click Yes.