Lenze 931E/K Small Drives Control - Manual (Page 186)

Appendix
Offline parameterisation
10
l
186 SW−HB 13.0002−EN 4.1
10.7 Offline parameterisation
The toolbar below the menu bar indicates if offline or online parameterisation is active:
Online parameterisation active Offline parameterisation active
The active mode will be highlighted in green.
The parameter setting program allows you to access parameter sets even if there is no
serial communication with the 931E/K servo positioning controller available. This is,
however, only possible, if a corresponding *.DCO file is available. See the chapter "Loading
and saving of parameter sets". (
¶ 183)
You can
ƒ read controller parameters from a *.DCO file.
ƒ change controller parameters.
ƒ save changed values in the same or a different *.DCO file.
ƒ print parameter sets. See the chapter "Printing parameter sets". (
¶ 184)
The changes will only become effective, if the modified parameter set is loaded into the
931E/K servo positioning controller. See the chapter "Loading and saving of parameter
sets". (
¶ 183)
The below figure shows the principle of the offline parameterisation:
931E_127
Fig. 37 Offline parameterisation
0 PC
1 *.DCO file
2 Small Drive Control (SDC)
Select the menu items Options
W Communication W Offline parameterisation or click the
offline icon in the toolbar to activate the offline parameterisation. You will be asked which
*.DCO file you want to open. Select a corresponding file.
(
Stop!
If you want to use a DCO file for a different device type, it is absolutely
necessary to check the settings for the rated current, maximum current, angle
encoder offset, phase sequence, pole pair number, current controller and
speed controller, otherwise, the servo positioning controller/motor might be
destroyed!
During the offline parameterisation, the behaviour of the parameter setting program