Lenze 931E/K Small Drives Control - Manual (Page 150)

Appendix
Parameterisation of outside motors
Display unit settings
10
l
150 SW−HB 13.0002−EN 4.1
)
Note!
The settings of the display units are selected independently of a possible
setpoint selection via the fieldbus. I.e. the settings of the display units do not
influence the factor group and the notation and dimension indices in
fieldbus−specific protocols such as the CANopen factor group!
Selection Units
Standard values For linear axes: Positions in distance units, speed in
[distance units]/sec; acceleration in [distance
units]/sec
@
For rotary drives: Positions in revolutions, degrees or
radian, different speed and acceleration units.
User−defined Examples:
l For linear axes and non−metric distance, speed and
acceleration units (e.g. inch, inch/min).
l For rotary drives with special distance, speed and
acceleration units.
Direct input Free selection of the distance, speed and acceleration
units.
For experienced users only!
Decimal places
Use the Decimal places tab to adapt the resolution of the displayed values to the "physical"
situation.