14 debugging the course program, Debugging the course program, Commissioning – Lenze 931E/K Small Drives Control User Manual
Page 89
Advertising
Commissioning
Course program
Debugging the course program
l
89
SW−HB 13.0002−EN 4.1
5.5.14
Debugging the course program
If you change to debug mode, additional status information will be displayed in the course
program window:
ƒ
Course program active: Will be on when the course program is active or being
processed.
ƒ
Course program stop: Will be on when the course program has been stopped by the
stop signal.
ƒ
NEXT1 / NEXT2: Indicates the current status of the digital inputs for NEXT1 & 2.
ƒ
DOUT1 / DOUT2: Indicates the current status of the digital outputs DOUT1 & 2.
ƒ
Line: Indicates the line currently processed by the course program. In the table, the
line will be highlighted in blue.
ƒ
Position: Indicates the last−approached position set.
931e_258
Advertising