Lenze 931E/K Small Drives Control - Manual (Page 49)

Commissioning
Torque control
Setpoint selection via setpoint selectors
5
l
49 SW−HB 13.0002−EN 4.1
Setpoint selection via RS232
If one of the setpoint sources is set to setpoint via RS232, open the menu Operating mode
W Setpoint selection RS232 to select the setpoint. The menu can also be opened by a click
on the "..." button next to the setpoint selector.
The following window appears:
Main
931e_220
The activated RS 232 sources will be marked with a green arrow.
Here, you can enter the setpoints and torque limitation. Click the red STOP symbol to stop
faulty entries immediately. After this, the setpoint will be set to 0 and transmitted
immediately.
If the setpoints are not to be transmitted immediately, uncheck Transmit immediately.
After this, new setpoints will only be transmitted, when the Transfer button is clicked.