Lenze 931E/K Small Drives Control - Manual (Page 161)

Appendix
Communication interfaces
Control via the serial interface
10
l
161 SW−HB 13.0002−EN 4.1
Transfer window
The Transfer window is used to send commands directly to the 931E/K servo positioning
controller and to monitor the response.
Select the menu command File
W Transfer to activate the Transfer window.
)
Note!
As long as the Transfer window is active, other open windows will not be
refreshed (e.g. actual values, oscilloscope).
Therefore, close the Transfer window, when it is no longer required.
In general, the Transfer window is only used to transfer commands that are not of interest
for standard operation. In addition, memory locations and communication objects can be
read and written. This is as well only necessary in special cases.
931e_336
For sending a command, enter it into the upper input line and press ENTER or click Send.