Lenze 931E/K Small Drives Control - Manual (Page 154)

Appendix
Parameterisation of outside motors
Direct entry of distance, speed and acceleration units
10
l
154 SW−HB 13.0002−EN 4.1
10.1.13 Direct entry of distance, speed and acceleration units
Direct input
If you have selected the option Direct input in the Display mode field in the Display units
tab, you can directly enter the Position, Speed and Acceleration factor group in the Direct
input tab.
(
Stop!
For experienced users only!
Through the direct entry of the physical units you can radically change the
control parameters of the 931E/K servo positioning controller.
You can select the following units for the display of the parameter setting program:
ƒ Increments
ƒ Degrees
ƒ Radians
ƒ Revolution
ƒ Metres
ƒ Millimetres
ƒ Micrometres
ƒ User−defined
ƒ No unit
In the example, e.g. in millimetres and hexadecimal format:
931e_310