Lenze 931E/K Small Drives Control - Manual (Page 85)

Commissioning
Course program
Type of command − Level test
5
l
85 SW−HB 13.0002−EN 4.1
5.5.11 Type of command − Level test
931e_254
Depending on the level of NEXT1, the program will continue execution in different lines.
NEXT1=HIGH NEXT1=LOW
931E_115
Fig. 11 Course program − level test
0 Line N
1 Line X
2 Line Y
3 Neither NEXT1 nor NEXT2
If the digital signal NEXT1 = HIGH, program execution will continue in line X. If the digital
signal NEXT1 = LOW, program execution will continue in line Y.
For an unconditional program jump (e.g. for never−ending loops), select the same jump
target for NEXT1=HIGH and NEXT1=LOW.
In Fig. 12, the level of NEXT1/2 is checked at the beginning of program step 11. Depending
on the result, the line of the next course program command will be determined.