12 type of command - end of program, Type of command − end of program, Commissioning – Lenze 931E/K Small Drives Control User Manual
Page 87
Advertising
Commissioning
Course program
Type of command − End of Program
l
87
SW−HB 13.0002−EN 4.1
5.5.12
Type of command − End of Program
931e_256
The current positioning process will be completed, then the program will be closed. No
digital outputs will be set/reset. No other positioning process will be started.
If Evaluate stop signal is activated, the current positioning process can be interrupted.
Advertising