Westermo GDW-11 - Manual (Page 104)

104 Short Messages commands 6615-2220
+CSCA – Service center address
Description:
This command is used to indicate to which service center the message must be sent.
The product has no default value for this address. If the application tries to send a mes-
sage without having indicated the service center address, an error will be generated.
Therefore, the application must indicate the SC address when initializing the SMS. This
address is then permanently valid. The application may change it if necessary.
Syntax:
AT+CSCA=<sca>
Parameters:
See table in beginning of section “short messages commands”
Command example Possible responses Note
AT+CMGS= “ +CMS ERROR: 330 Service center unknown
+33146290800”<CR>
Hello, how are you?<ctrl-Z>
AT+CSCA=”0696741234” OK Service center initialization
AT+CMGS=”+33146290800” +CMGS: 1 Successful transmission
<CR>
Happy Birthday!<ctrl-Z>
OK
+CSCB – Select Cell Broadcast Message Types
Description:
This command selects which types of CBMs are to be received by the ME. It is allowed in
both PDU and text modes.
Syntax:
AT+CSCB= <mode>, [ <mids>, [ <dcss> ] ]
Parameters:
<mode>
0: Message types specified in <mids> and <dcss> are accepted
1: Message types specified in <mids> and <dcss> are not accepted
<mids>
Indicates to which type of message identifiers the ME should listen.