Westermo GDW-11 - Manual (Page 243)

GPRS commands 243 6615-2220
+WGPRS – GPRS parameters customization
Description:
This command modifies some WESTERMO GPRS parameters:
… the ATTACH-STATUS (the ME does or not perform automatically a GPRS
attachment after initialization),
… the PDP-INIT-STATUS (activates automatically or not some defined PDP contexts
after initialization) and
… the user-defined multislot class. This parameter represents the GPRS class chosen
by the user to perform power saving (by reducing TX (or uplink) time slots).
In addition, this command permits to
… set automatically “ACTIVABLE” some defined PDP contexts after initialization,
… set some parameters for PALM® OS software: PPP Silent Mode (PPP waits for PPP
Client to start the dialog) and Slow CONNECT (due to the delay of the process-
ing of PALM® OK, the CONNECT is sent one second after the dialing command
request)
… PPP Filtering is a specific parameter for validation team
(Note: this parameter is not save and is set to OFF after reboot).
NOTE:
The modem must be rebooted to activate the new setup except for <mode>
3, 5 and 6 (please refer to the Parameters paragraph).
Syntax:
AT+WGPRS=<mode>,<parameter>[,<cid>][,<class>]
Response Syntax:
AT+WGPRS=?
+WGPRS: <mode>, <parameter1>[,<cid>]
[+WGPRS: <mode>, <parameter>[,<cid>]
[...]]
AT+WGPRS?
+WGPRS:<mode>(list of supported <parameter>) [,(list of supported <cid>)]
[+WGPRS:<mode>(list of supported <parameter>) [,(list of supported <cid>)] [. . .]]