Westermo GDW-11 - Manual (Page 41)

Network service commands 41 6615-2220
Parameters:
<mode>
0: use long alphanumeric format
1: use short alphanumeric format
2: reserved for later use
3: Erase NITZ PLMN list if <NumOper> = 0
4: Acces to EEPREOM to read or write the method used for getting PLMN names,
Read access if <NumOper> omitted, write access if <NumOper> (=PlmnOns)
provided.
<NumOper>
Is the operator in numeric format.
<AlphaOper>
Is the operator in long is shirt alphanumeric format (see codes and values for operator
names description)
<lac>
Is the two bytes Location Area Code to be used to get the PLMN name. If it is not
entered, current lac will be used (0 if limited service). It is provided as an integer value.
<lmnOns>
Is a bit field with following coding:
Bit 0 E-ONS
Bit 1 CPHS
Bit 2 SPN
Bit 3 NITZ
Bit 4 FLASH
Bit 4 (FLASH) Bit 3 (NITZ) Bit 2 (SPN) Bit 1 (CPHS) Bit 0 (E-ONS)
Bit value is 1 for activate and 0 for deactivate the method. <PlmnOns> value should be
provided as a decimal value.
1 1 1 4 1
NOTE: for example <PlmnONs>=31 means that the four methods will be used for
PLMN names (bit field value is 1111 of 0x1F)