Westermo GDW-11 - Manual (Page 137)

Data commands 137 6615-2220
+CR – Service reporting control
Description:
This command enables a detailed type of service reporting in the case of incoming or
outgoing data calls. Before sending the CONNECT response to the application, the prod-
uct will specify the type of data connection that has been set up.
These report types are:
+CR: ASYNC For asynchronous transparent
+CR: REL ASYNC For asynchronous non-transparent
Syntax:
AT+CR=<mode>
Parameters:
<mode>
0: disable extended reports
1: enable extended reports
Command example Possible responses Note
AT+CR=0 OK Extended reports disabled
AT+CR=1 OK Extended reports enabled
AT+CR? +CR: 1 Current value
OK
AT+CR=? +CR: (0,1) Possible values
OK