Westermo GDW-11 - Manual (Page 204)

204 Specific AT commands 6615-2220
+WRST – Reset command
Description:
This command resets the modem after the time specified by the <delay> parameter.
Syntax.
AT+WRST =<Mode>,<Delay>
Response syntax:
+WRST: <Mode>,<Delay>,<RemainTime>
Parameters:
<val1>
0: timer reset is disabled
1: timer reset is enabled
<Delay>
sets the time before reset
Range “000:01”- “168:59” (format hhh:mm)
<RemainTime>
time before next reset
Range “000:01”- “168:59” (format hhh:mm)
Command example Possible responses Note
AT+WRST=? OK
AT+WRST=0 OK Disable timer
AT+WRST=1,”001:03” OK Enable timer and set delay
at 1 hour 3 minutes
AT+WRST? +WRST: 1,”001:03”,”001:01” Timer activated to reset
OK after 1 hour and 3 minutes.
At this point, 1 hour and 1
minute remain before next
reset.