Westermo GDW-11 - Manual (Page 75)

Phonebook commands 75 6615-2220
+WAIP – Avoid phonebook init
Description:
This specific command allows the initialization of all phonebooks to be inhibited during
subsequent boots.
Syntax:
AT+WAIP=<mode>
Parameters:
<mode>
0: Normal initialization (with phonebooks)
1: No phonebook initialization
Command example Possible responses Note
AT+WAIP? +WAIP:0 Current values ?
OK Default value
(init phonebooks)
AT+WAIP=? +WAIP: (0,1) Possible values ?
OK
AT+WAIP =1 OK Inhibit initialization of
phonebooks (next boot
AT&W Save modifications in
EEPROM
Caution:
The given value should be stored in EEPROM. Therefore, the AT&W command must be
used to save the new <mode> value.
NOTE:
… No phonebook commands are allowed if +WAIP=1 (after boot).
… If a phonebook command is entered, a “+CME ERROR: 3” is returned.