Tcp socket autoconnect commands, Wtcpconnect – tcp socket link control, Wtcpmode – tcp client server select – Westermo GDW-11 User Manual
Page 260
260 TCP SOCKET AUTOCONNECT Commands
6615-2220
TCP SOCKET AUTOCONNECT Commands
*WTCPCONNECT – TCP socket link control
Description:
This command is used to enable or disable the TCP socket link control. When enabled, the
modem will automatically after power on, set up connections to a packet switched network
and start working either as a TCP server or a client (depending on configuration).
Syntax:
AT*WTCPCONNECT=<mode>
Parameters:
<mode>
1= enabled
0=disabled
Command example
Possible responses
Note
AT*WTCPCONNECT=1 OK
Enable TCP link control
AT*WTCPCONNECT? *WTCPCONNECT:
1
Show
value
OK
AT*WTCPCONNECT=?
*WTCPCONNECT: (0,1)
Show range
OK
*WTCPMODE – TCP client server select
Description:
This command is used to select if the modem shall act as a client or server in a TCP
socket link.
Syntax:
AT*WTCPMODE=<mode>
Parameters:
<mode>
1= server
0=client
Command example
Possible responses
Note
AT*WTCPMODE =1
OK
Set modem to work in
server mode
AT*WTCPMODE? *WTCPMODE:
1
Show
value
OK
AT*WTCPMODE =?
WTCPMODE: (0,1)
Show range
OK