Westermo GDW-11 - Manual (Page 264)

264 TCP SOCKET AUTOCONNECT Commands 6615-2220
*WTCPTXDELAY – TCP Socket port for TCP Socket autoconnect
Description:
This command configures the delay (expressed in milliseconds) before the socket trans-
mits the characters to the remote modem. This parameter is needed to keep the TCP
communication effective with respect to packet overhead data.
Syntax:
AT*WTCPTXDELAY =<Delay>
Parameters:
<Delay>
The delay can be configured in 20 ms steps. Value can be from 0 to 32760. Default value
is 100 ms.
Command example Possible responses Note
AT*WTCPTXDELAY =200 OK Set command with delay
value 200 milliseconds
AT*WTCPTXDELAY? *WTCPTXDELAY: 200 Current value
AT*WTCPTXDELAY =? *WTCPTXDELAY: (0-32760) Test command
AT*WTCPI – TCP connect status information
Description:
This command controls if detailed status information should be reported when
using the TCP connect functionality. Reported event are:
… Registration status
… GPRS session status
… TCP session status
… IP-address
Syntax:
AT*WTCPI= <mode>
Parameters:
<mode>
1: Displays some status information during a TCP connection
0: No information is displayed during TCP connection
Command example Possible responses Note
AT*WTCPI=1 OK Enable status information
AT*WTCPI? *WTCPI: 1 Show current value
OK
AT*WTCPI=? *WTCPI: (0,1) Show range
OK