Westermo GDW-11 User Manual
Page 244

244 GPRS commands
6615-2220
Parameters:
<mode>
A numeric parameter which specifies a WESTERMO GPRS parameter.
0:
ATTACH-STATUS (the ME don’t make automatically a GPRS attachment after init)
1:
PDP-INIT-STATUS (declare some PDP contexts liable to be activated automatically
after initialization by <mode>=2)
2:
Set ACTIVABLE automatically after init a define PDP context
3:
PPP silent mode
4:
definition of the GPRS multislot class.
5:
Slow CONNECT for PALM® OS
6: PPP
Filtering
NOTE:
… If <mode>=0, 1, 3, 4, 5 or 6, <cid> and <class> values will be ignored.
… If <mode>=0, 1, 2, 3, 5 or 6, <class> value will be ignored.
… If <mode>=4, <parameter> and <cid> values will be ignored.the modem must be
restarted to take the modification into account.
… PPP Filtering is a test-purpose functionality. It avoids sending on the radio link some
OS-specific frames, for accurate transfer rate measurements.
<parameter>
A numeric parameter that controls the operation defined by <mode> if it is equal to 0,
1, 2 or 3.
0:
operation OFF (disabled)
1:
operation ON (enabled)
<cid>
(PDP Context Identifier) a numeric parameter which specifies a particular PDP context
definition. The parameter is local to the TE-MT interface and is used in other PDP
context-related commands. Range of values is 0 to 4.
<class>
GPRS multislot class number. It may be lower than the maximum possible class. Possible
values are 2, 8, 10, 12. Refer to doc ref [6] for more information about GPRS multislot
classes.