Westermo GDW-11 - Manual (Page 185)

Specific AT commands 185 6615-2220
+WSTR – Status Request
Description:
This command returns some operation status. It can be used for example to check
the state of the initialization sequence; the different values returned are Not started,
Ongoing, Finished.
Syntax:
AT+WSTR=<status>
Response syntax:
+WSTR: <status>,<value>
Parameters:
<status>
1: Initialization sequence
<value>
0: Not started
1: On going
2: Finished
2: Network
status
<value>
0: No network
1: Network available
Command example Possible responses Note
AT+WSTR=1 +WSTR: 1,2 Select the status 1 (INIT
OK SEQUENCE)
Init finished
AT+WSTR=2 +WSTR: 2,1
OK Select the status 2
(NETWORK STATUS)
The network is available
AT+WSTR=? +WSTR: (1-2) Ask for the list of possible
values