Ilrr – dte-dce local rate reporting – Westermo GDW-11 User Manual
Page 139
Data commands 139
6615-2220
+ILRR – DTE-DCE local rate reporting
Description:
This parameter controls whether the extended-format “+ILRR: <rate>” information text
is transmitted from the DCE to the DTE or not. The <rate> value reported represents
the current (negotiated or renegotiated) DTE-DCE speed rate.
If enabled, the intermediate result code is transmitted in an incoming or outgoing data
call, after any data compression report, and before any final result code (CONNECT).
Syntax:
AT+ILRR = <value>
Parameters:
<value>
0:
disable local port rate report
1:
enable local port rate report
<rate>
Can take the following values: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600,
115200 (kbit/s).
Command example
Possible responses
Note
AT+ILRR=0
OK
Local port rate report
disabled
AT+ILRR=1
OK
Local port rate report
enabled
AT+ILRR?
+ILRR: 1
Current value
OK
AT+ILRR=?
+ILRR: (0,1)
Possible values
OK