Yaskawa PC NC - Manual (Page 124)

3 - 67
YASNAC PCNC Operating Manual Chapter 3: HMI Process Operation
FIGURE 3.7.4.2. Configuration Screen - Drive Configuration
The Drive Configuration tab of the Maintenance:Configuration screen, shown in Figure 3.7.4.2
on page 67, displays the types of servo packs and servo motors installed on the NC. This informa-
tion is for display purposes only and is not editable.
Setting the YENET station numbers:
• Go to the Drive Configuration tab of the Maintenance:Configuration screen to observe
the current YENET station numbers. They will be something like “2”, “3” and “4”.
• Switch to the Utilities:Login screen and log in as Machinist (or higher).
• Change to the Maintenance:Parameter Search screen and check the Search checkbox in
the top left corner of the screen. Set the search kind to Label, then type in “station number”
and hit Enter. This should display all the YENET station number parameters.
• Change the station numbers for the 1st, 2nd and 3rd axes (pm 1020 -1022) by selecting
new values in the drop-down menus.
• Press reset, then shut down and boot up the PCNC.
• Go to the Drive Configuration tab of the Maintenance:Configuration screen to see the
changed station numbers.