Yaskawa PC NC - Manual (Page 350)

A3 - 110
YASNAC PCNC Operating Manual APPENDIX 3: Parameter Tables
Motion
Address Bit Description
Register
Units
Minimum
Value
Maximum
Value
Long Description
860 Deceleration feedrate by corner
feedrate "mm" mm/min 0 240000 Deceleration feedrate
by corner feedrate
designation function,
“mm” mode (P)
861 Deceleration distance by corner
feedrate “mm” 0.001mm 0 999999999 Deceleration distance
by corner feedrate
designation function,
“mm” mode (L)
862 Deceleration feedrate by corner
feedrate “inch” 0.1inch/min 0 94488 Deceleration feedrate
by corner feedrate
designation function,
“inch” mode (P)
863 Deceleration distance by corner
feedrate
“inch”
0.0001inch 0 393700787 Deceleration distance
by corner feedrate
designation function,
“inch” mode (L)
1000 7 SAGR check when rapid to feed
0: Not checked
1: Checked 0 1 Checking of SAGR
when feed rate is
changed from rapid to
feed
4015 3 In-position check at the completion
of G04
1: Checked
0: Not checked 0 0
4 In-position check when G code is
changed to G00
0: Not checked
1: Checked 0 1
4461 1st axis overtravel distance in G60 0.001mm 0 32767
4462 2nd axis overtravel distance in G60 0.001mm 0 32767
4463 3rd axis overtravel distance in G60 0.001mm 0 32767
4464 4th axis overtravel distance in G60 0.001mm 0 32767
4465 5th axis overtravel distance in G60 0.001mm 0 32767
4820 Allowable error range when arc
radius is specified 0.001mm 0 999999999