Yaskawa PC NC - Manual (Page 285)

A3 - 45
YASNAC PCNC Operating Manual APPENDIX 3: Parameter Tables
Canned Cycle
Address Bit Description
Register
Units
Minimum
Value
Maximum
Value
Long Description
pm400 Dwell period for G76, G77 msec 0 32767
pm401 Pitch dwell period for G73, G83 msec 0 32767
pm805 Angle when G76, G77
are specified 0.001deg 0 360000
pm870 Return amount of G73 0.001mm 0 999999999 Return stroke in G73
cycle (rapid traverse)
pm871 Return amount of G83 0.001mm 0 999999999 Return stroke in G83
cycle (rapid traverse)
pm873 Return amount of G184/G174 0.001mm 0 999999999 Return stroke in G184/
G174 cycle (rapid
traverse)
pm2864 Shift speed of canned cycle
G76 and G77 mm/min 0 240000
pm4016 1 Positioning mode in a canned cycle
0: G00
1: G00 or G01 which ever is present 0 1
2 M code to be output in the
G74/G84 canned cycle
0: M code reverse one specified
before start
1: M03 for G74 and M04 for G84 0 1
3 Output M05 at hole bottom in G74/
G84 cycle
0: No
1: Yes 0 1
4 Execution type of G184/G174
1: Pecking cycle (type B)
0: Return to R-point 0 1
6 Solid tap in Dry run mode
0: Normal tap
1: Solid tap 0 1
pm4017 1 Output of M05 before the output of
M19 in the
0: No
1: Yes 0 1
2 Spindle over-ride during the
execution of G84/G74 tap cycle
0: Fixed at 100%
1: Fixed at the value read at the start 0 1
3 Validity of pm0400 dwell time
in the G76/G77 cycle
1: Valid
0: Invalid 0 1
4 Validity of pm0401 pitch dwell time
1: Valid
0: Invalid 0 1