Yaskawa PC NC - Manual (Page 220)

A2 - 9
YASNAC PCNC Operating Manual Appendix 2: Alarm Tables
Alarm
No.
Description
alarm.1000 DNC time-out error has occurred.
alarm.1001 DNC DR line error has occurred.
alarm.1002 DNC packet length error has occurred.
alarm.1003 DNC 8251 error has occurred.
alarm.1004 DNC check sum error has occurred.
alarm.1005 DNC command error has occurred.
alarm.1006 DNC high-speed cutting mode error has occurred.
alarm.1007 DNC communication module diagnosis error has occurred.
alarm.1008 DNC CPU error has occurred.
alarm.1009 DNC 51 error has occurred.
alarm.1020
Start number of the battery backed-up memory storing the cell controller I/0 link information is outside the
allowable range.
alarm.1021 An interface error between the cell controller and COM in the cell controller system.
alarm.1041 Incorrect command has been made for the PLC control axis (X-axis).
alarm.1042 Incorrect command has been made for the PLC control axis (Y-axis).
alarm.1043 Incorrect command has been made for the PLC control axis (Z-axis).
alarm.1044 Incorrect command has been made for the PLC control axis (4th-axis).
alarm.1045 Incorrect command has been made for the PLC control axis (5th-axis).
alarm.1051 Axis has been changed while the control axis selected status signal is ON (X-axis).
alarm.1052 Axis has been changed while the control axis selected status signal is ON (Y-axis).
alarm.1053 Axis has been changed while the control axis selected status signal is ON (Z-axis).
alarm.1054 Axis has been changed while the control axis selected status signal is ON (4th-axis).
alarm.1055 Axis has been changed while the control axis selected status signal is ON (5th-axis).
alarm.1080 Execution of a program block has been stopped with the ERR 0 signal ON.
alarm.1090 Setting area total check error has occurred.
alarm.1091 Parameter area total check error has occurred.