Yaskawa PC NC - Manual (Page 78)

3 - 21
YASNAC PCNC Operating Manual Chapter 3: HMI Process Operation
O00007
N1G04P1.
N2G04P1.
N3G04P1.
N4G04P1.
N5G04P1.
N6G04P1.
N7G04P1.
N8G04P1.
N9G04P1.
M30
• Set the mode to Memory and start execution of O00007. The green arrow indicates the
currently executing line.
• Select single block on the machine panel. Once the program stops executing, the arrow
color will be white, and the arrow will be pointing at the next line to be executed. The
sequence number for this line will be shown above the program display area.
• Switch to the Program:Editor screen and move the cursor to the desired new start
position.
• Click the Run At Cursor button. The Run:Production screen will be shown, and the
running pointer should indicate the newly specified starting line.
• Press cycle start. The next block to execute is the N4G04P1. block. The sequence number
shows N4 initially, then changes to the next line (N5).
3.2.3 Nest Level Display
This display is useful if the program is executing nested sub-programs. There may be up to 8 lev-
els of nesting, and the nest level is shown on the right. The program or subprogram name is shown
on the left. The Nest Display toggle on the Run:Proveout screen controls whether this component
is shown.