8 5th-axis command neglect – Yaskawa PC NC User Manual
Page 52
Advertising
2 - 29
YASNAC PCNC Operating Manual Chapter 2: Basic Operation of YASNAC PCNC
The switch can be operated only while the operation is stopped in the block stop or feed hold
state.
2.7.8
5th-axis Command Neglect
When the 5TH-AXIS COMMAND NEGLECT switch is ON, the program is executed with the
machine lock function applied only to the 5th-axis. Although the 5th-axis does not move, posi-
tion data of the 5th-axis are updated as the program is executed.
The switch can be operated only while the operation is stopped in the block stop or feed hold
state.
Advertising