Yaskawa PC NC - Manual (Page 418)

A3 - 178
YASNAC PCNC Operating Manual APPENDIX 3: Parameter Tables
1511 No. of teeth of gear A on the spindle
intermediate tooth 0 32767 No. of teeth of the spin-
dle intermediate gear A
used for spindle loop
control.
If there is no intermedi-
ate gear, set motor side
one
1512 No. of teeth of gear A on the motor
intermediate tooth 0 32767 No. of teeth of the
motor intermediate gear
A used for spindle loop
control.
If there is no intermedi-
ate gear, set 0
1513 No. of teeth of gear A on the motor
side intermediate tooth 0 32767 No. of teeth on the
motor side of gear A
used for spindle loop
control.
If there is no intermedi-
ate gear, set 0.
1514 No. of teeth of gear B on the spindle
side tooth 0 32767 No. of teeth of gear B
on the spindle side for
spindle loop control.
1515 No. of teeth of gear B on the spindle
intermediate tooth 0 32767 No. of teeth of the spin-
dle intermediate gear B
used for spindle loop
control.
If there is no intermedi-
ate gear, set 0.
1516 No. of teeth of gear B on the motor
intermediate tooth 0 32767 No. of teeth of the
motor intermediate gear
B used for spindle loop
control
If there is no intermedi-
ate gear, set 0
1517 No. of teeth of gear B on the motor
side intermediate tooth 0 32767 No. of teeth on the
motor side of gear B
used for spindle loop
control.
If there is no intermedi-
ate gear, set 0.
2000 1 Dry run during thread cutting 0 1
2831 1st axis bias in thread cutting accel/
decel mm/min,
deg/min
0 240000
2832 2nd axis bias in thread cutting accel/
decel mm/min,
deg/min
0 240000
2833 3rd axis bias in thread cutting accel/
decel mm/min,
deg/min
0 240000
2834 4th axis bias in thread cutting accel/
decel mm/min,
deg/min
0 240000
2835 5th axis bias in thread cutting accel/
decel mm/min,
deg/min
0 240000
Address Bit Description
Register
Units
Minimum
Value
Maximum
Value
Long Description