Figure 4-9, Setting the startup code -19, Figure 4-10 deleting files -19 – SMC Networks TigerAccess SMC7816M User Manual
Page 101
M
ANAGING
F
IRMWARE
4-19
If you download to a new destination file, go to the File Management, Set
Start-Up menu, mark the operation code file used at startup, and click
Apply. To start the new firmware, reboot the system via the System/Reset
menu.
Figure 4-9 Setting the Startup Code
To delete a file select System, File Management, Delete. Select the file
name from the given list by checking the tick box and click Apply. Note
that the file currently designated as the startup code cannot be deleted.
Figure 4-10 Deleting Files
CLI – To download new firmware form a TFTP server, enter the IP
address of the TFTP server, select “config” as the file type, then enter the
source and destination file names. When the file has finished downloading,
set the new file to start up the system, and then restart the switch.