SMC Networks TigerAccess SMC7816M - Manual (Page 691)

L
ONG
-R
EACH
E
THERNET
C
OMMANDS
29-9
Example
This example sets a HAM band notch in the transmitted power spectrum
in the 10.000 - 10.150 MHz transmission band (also called the 30 meter
band).
Related Commands
show lre ham-band (29-64)
lre region-ham-band (29-9)
lre region-ham-band
This command sets the ham radio band that will be blocked to VDSL
signals based on defined usage types. Use the no form to restore the
default status.
Syntax
lre region-ham-band value
no lre region-ham-band
value – HAM band mask for designated usage type.
(See Table 29-5, “HAM Band Notches for Usage Types,” on
page 29-10.)
Default Setting
36 (none)
Command Mode
Global Configuration
Interface Configuration (VDSL Port)
Command Usage
• Enter this command in global configuration mode to set a HAM band
mask for a designated usage type for all VDSL ports, or in interface
mode to set a mask for a specific VDSL port.
Console(config)#interface ethernet 1/1
Console(config-if)#lre ham-band 11
Console(config-if)#