SMC Networks TigerAccess SMC7816M - Manual (Page 902)

M
ULTICAST
F
ILTERING
C
OMMANDS
35-26
mvr (Interface Configuration)
This command configures an interface as a static member of an MVR
domain using the group keyword, or configures an interface as an MVR
receiver or source port using the type keyword. Use the no form to restore
the default settings.
Syntax
[no] mvr
{domain domain-id [group ip-address |type {receiver | source}] |
group ip-address | type {receiver | source}}
• domain-id - An independent multicast domain. (Range: 1-3)
• ip-address - Statically configures an interface to receive multicast
traffic from the IP address specified for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
• receiver - Configures the interface as a subscriber port that can
receive multicast data.
• source - Configure the interface as an uplink port that can send and
receive multicast data for the configured multicast groups.
Default Setting
• MVR domain ID is 1.
• The port type is not defined.
• No port is a member of any configured multicast group.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• MVR source ports and receiver ports can be members of more than
one MVR domain. However, an interface cannot be receiver port in
one MVR domain and a source port in another domain.
• A port which is not configured as an MVR receiver or source port can
use IGMP snooping to join or leave multicast groups using the
standard rules for multicast filtering.
• Receiver ports can belong to different VLANs. IGMP snooping can
be used to allow a receiver port to dynamically join or leave multicast