SMC Networks TigerAccess SMC7816M - Manual (Page 698)

VDSL C
OMMANDS
29-16
Example
The following sets a PSD value for the frequency band bounded by
breakpoints 1 and 2 to -20 dBm/Hz on VDSL port 1.
Related Commands
lre psd-breakpoints (29-12)
lre psd-frequencies (29-13)
show lre psd (29-67)
lre psd-mask-level (29-16)
lre psd-mask-level
This command sets a predefined PSD mask. Use the no form to restore
the default setting.
Syntax
lre psd-mask-level value
no lre psd-mask-level
value – Index for a predefined PSD mask.
(See Table 29-6, “PSD Mask Options,” on page 29-17.)
Default Setting
5 (Annex F)
Command Mode
Global Configuration
Interface Configuration (VDSL Port)
Command Usage
• Enter this command in global configuration mode to set a predefined
PSD mask for all VDSL ports, or in interface mode to set a mask for
a specific VDSL port. Note that this switch is specifically designed to
meet the requirements for G.993.2, Annex C for Japan. We do not
therefore recommend changing the mask without careful testing.
Console(config)#interface ethernet 1/1
Console(config-if)#lre psd-value 1 240
Console(config-if)#lre psd-value 2 240
Console(config-if)#