SMC Networks TigerAccess SMC7816M - Manual (Page 58)

B
ASIC
C
ONFIGURATION
2-8
9. Then follow the steps indicated in the next section to assign an IP
address to this VLAN using manual configuration or automatic
configuration via DHCP or BOOTP.
Note: If you put the uplink ports (Ports 17 and 18) in a separate
management VLAN, do not change their default VLAN ID. Nor
should you remove these ports from the VLAN used for the data
network. All data ports, both uplink and downlink, should be
included in the same VLAN for normal operations (i.e., VLAN 1
by default).
You can configure an IP address in either of the following ways:
Manual — You have to input the information, including IP address and
subnet mask. If your management station is not in the same IP subnet as
the switch, you will also need to specify the default gateway router.
Dynamic — The switch sends IP configuration requests to BOOTP or
DHCP address allocation servers on the network.
Manual Configuration
You can manually assign an IP address to the switch. You may also need to
specify a default gateway that resides between this device and management
stations that exist on another network segment. Valid IP addresses consist
of four decimal numbers, 0 to 255, separated by periods. Anything outside
this format will not be accepted by the CLI program.
Note: An IP address for this switch is obtained via DHCP by default.
Console(config)#vlan database 32-7
Console(config-vlan)#vlan 2 name management media ethernet 32-8
Console(config-vlan)#exit
Console(config)#interface ethernet 1/19
25-2
Console(config-if)#switchport allowed vlan add 2 untagged 32-14
Console(config-if)#switchport native vlan 2
32-13
Console(config-if)#switchport allowed vlan remove 1
Console(config-if)#