SMC Networks TigerAccess SMC7816M - Manual (Page 359)

C
ONFIGURING
IEEE 802.1Q T
UNNELING
13-29
4. Set the Tag Protocol Identifier (TPID) value of the tunnel port. This
step is required is the attached client is using a nonstandard 2-byte
ethertype to identify 802.1Q tagged frames. The standard ethertype
value is 0x8100. (See “Adding an Interface to a QinQ Tunnel” on page
13-30.)
5. Configure the QinQ tunnel port to join the SPVLAN as an untagged
member (see “Adding Static Members to VLANs (VLAN Index)” on
page 13-12).
6. Configure the SPVLAN ID as the native VID on the QinQ tunnel port
(see “Configuring VLAN Behavior for Interfaces” on page 13-15).
7. Configure the QinQ uplink port to join the SPVLAN as a tagged
member (see “Adding Static Members to VLANs (VLAN Index)” on
page 13-12).