SMC Networks TigerAccess SMC7816M - Manual (Page 712)

VDSL C
OMMANDS
29-30
lre shutdown
This command shuts down a VDSL port. Use the no form to re-enabled a
port.
Syntax
[no] lre shutdown
Default Setting
All VDSL ports are operational
Command Mode
Interface Configuration (VDSL Port)
Command Usage
Use this command to disable the VDSL chipset transmitter of a VDSL
port that is not connected to a working CPE. In some unusual
circumstances, the power emitted by VDSL ports can affect other
VDSL ports. It is recommended that ports that are not wired to CPEs
be shut down in this way. Also use this command to disable access to
the switch from this port for troubleshooting or security reasons.
Example
The following example disables VDSL port 1.
lre reset
This command resets the VDSL controller chip for the specified VDSL
port or the connected CPE. Use the no form to re-enabled a port.
Syntax
lre reset {local | remote}
• local – VDSL2 chip at specified switch port.
• remote – VDSL2 chip at CPE connected to specified switch port.
Console(config)#interface ethernet 1/1
Console(config-if)#lre shutdown
Console(config-if)#