SMC Networks TigerAccess SMC7816M - Manual (Page 60)

B
ASIC
C
ONFIGURATION
2-10
To automatically configure the switch by communicating with BOOTP or
DHCP address allocation servers on the network, complete the following
steps:
1. From the Global Configuration mode prompt, type “interface vlan 1”
to access the interface-configuration mode. Press <Enter>.
2. At the interface-configuration mode prompt, use one of the following
commands:
• To obtain IP settings via DHCP, type “ip address dhcp” and press
<Enter>.
• To obtain IP settings via BOOTP, type “ip address bootp” and
press <Enter>.
3. Type “end” to return to the Privileged Exec mode. Press <Enter>.
4. Reset the switch by entering the “reload” command.
5. Wait a few minutes for the switch to reboot, and then check the IP
configuration settings by typing the “show ip interface” command.
Press <Enter>.
6. Then save your configuration changes by typing “copy running-config
startup-config.” Enter the startup file name and press <Enter>.
Console(config)#interface vlan 2 25-2
Console(config-if)#ip address dhcp 38-2
Console(config-if)#end
Console#reload
19-5
.
.
.
Console#show ip interface
38-4
IP address and netmask: 192.168.1.54 255.255.255.0 on VLAN 1,
and address mode: DHCP
Console#copy running-config startup-config
20-17
Startup configuration file name []: startup
\Write to FLASH Programming.
\Write to FLASH finish.
Success.