SMC Networks TigerAccess SMC7816M - Manual (Page 444)

O
VERVIEW OF THE
C
OMMAND
L
INE
I
NTERFACE
18-6
The command “show interfaces ?” will display the following information:
Partial Keyword Lookup
If you terminate a partial keyword with a question mark, alternatives that
match the initial letters are provided. (Remember not to leave a space
between the command and question mark.) For example “s?” shows all the
keywords starting with “s.”
Negating the Effect of Commands
For many configuration commands you can enter the prefix keyword “no”
to cancel the effect of a command or reset the configuration to the default
value. For example, the logging command will log system messages to a
host server. To disable logging, specify the no logging command. This
guide describes the negation effect for all applicable commands.
sntp SNTP
spanning-tree Specify spanning-tree
ssh Secure shell
startup-config The system configuration of starting up
system Information of system
tacacs-server Login by TACACS server
users Display information about terminal lines
version System hardware and software status
vlan Switch VLAN Virtual Interface
Console#show
Console#show interfaces ?
counters Information of interfaces counters
efm Efm
protocol-vlan Protocol-vlan information
status Information of interfaces status
switchport Information of interfaces switchport
Console#
Console#show s?
snmp sntp spanning-tree ssh
startup-config system
Console#sh s