SMC Networks TigerAccess SMC7816M - Manual (Page 708)

VDSL C
OMMANDS
29-26
Related Commands
lre channel (29-24)
show lre interleave-max-delay (29-72)
lre datarate
This command specifies the minimum and maximum data rate for
downstream and upstream fast or slow (interleaved) channels. Use the no
form to restore the default setting.
Syntax
lre datarate {down | up} {slow | fast} {max | min} value
no lre datarate {down | up} {slow | fast} {max | min}
• down – Downstream bands.
• up – Upstream bands.
• slow – Slow (interleaved) channel.
• fast – Fast channel.
• max – Maximum channel data rate.
• min – Minimum channel data rate.
• value – The data rate. (Range: 1-200,000 kbps)
Default Setting
Maximum data rate: 200,000 kbps
Minimum data rate: 64 kbps
Command Mode
Interface Configuration (VDSL Port)
Command Usage
The command sets the minimum and maximum data rates supported
by each upstream and downstream band. Bounding data rates should
be set for both fast and slow channels if operation may sometimes
disable or enable interleaving. These bounds are applied to the specified
interface when rate adaption is enabled (see Command Usage,
page 29-32).