Ip acls, Ip acls -2, Table 24-2 ip acl commands -2 – SMC Networks TigerAccess SMC7816M User Manual
Page 616: 2 ip acls
A
CCESS
C
ONTROL
L
IST
C
OMMANDS
24-2
IP ACLs
The commands in this section configure ACLs based on IP addresses,
TCP/UDP port number, protocol type, and TCP control code. To
configure IP ACLs, first create an access list containing the required permit
or deny rules, set a precedence mask to control the filter sequence, and
then bind the access list to one or more ports
Table 24-2 IP ACL Commands
Command
Function
Mode
Page
access-list ip
Creates an IP ACL and enters
configuration mode for standard or
extended IP ACLs
GC
permit, deny
Filters packets matching a specified
source IP address
IP-
STD-ACL
permit, deny
Filters packets meeting the specified
criteria, including source and
destination IP address, TCP/UDP port
number, protocol type, and TCP
control code
IP-
EXT-ACL
show ip access-list Displays the rules for configured IP
ACLs
PE
access-list ip
mask-precedence
Changes to the IP Mask mode used to
configure access control masks
GC
mask
Sets a precedence mask for the ACL
rules
IP-Mask
show access-list ip
mask-precedence
Shows the ingress or egress rule masks
for IP ACLs
PE
ip access-group
Adds a port to an IP ACL
IC
show ip
access-group
Shows port assignments for IP ACLs
PE