SMC Networks TigerAccess SMC7816M - Manual (Page 754)

VDSL C
OMMANDS
29-72
Related Commands
lre tone (29-21)
show lre interleave-max-delay
This command displays the maximum interleave-delay that can be used for
downstream and upstream channels.
Syntax
show lre interleave-max-delay [unit/port]
• unit - Stack unit. (Range: 1)
• port - Port number. (Range: 1-16)
Command Mode
Privileged Exec
Command Usage
• Use this command without the interface parameter to show the
maximum interleave delay for all VDSL ports on the switch, or with
an interface to display this information for a specific port.
• Interleave delay applies only to the interleave (slow) channel and
defines the mapping (relative spacing) between subsequent input bytes
at the interleaver input and their placement in the bit stream at the
interleaver output. Larger numbers provide greater separation
between consecutive input bytes in the output bit stream allowing for
improved impulse noise immunity at the expense of payload latency.
Example
This example shows the default settings for the maximum interleave delay.
Related Commands
lre interleave-max-delay (29-25)
Console#show lre interleave-max-delay 1/1
Downstream InterleaveDelay Max: 2 ms
Upsteam InterleaveDelay Max: 2 ms
Console#