SMC Networks TigerAccess SMC7816M - Manual (Page 685)

L
ONG
-R
EACH
E
THERNET
C
OMMANDS
29-3
lre max-power Sets the maximum aggregate downstream
or upstream power GC/IC 29-22
lre min-protection Configures the minimum level of impulse
noise protection for all bearer channels IC 29-23
lre channel Sets the channel mode to fast or
interleaved IC 29-24
lre
interleave-max-delay Sets the maximum interleave delay IC 29-25
lre datarate Specifies the minimum and maximum
data rate for downstream and upstream
fast or slow (interleaved) channels IC 29-26
lre rate-set Sets the maximum input and output data
rates for VDSL ports GC/IC 29-27
lre noise-mgn target Configures the targeted signal-to-noise
margin that VDSL ports must achieve to
successfully complete initialization IC 29-28
lre noise-mgn min Configures the minimum acceptable
signal-to-noise margin IC 29-28
lre shutdown Shuts down a VDSL port IC 29-30
lre reset Resets the VDSL controller chip for the
specified port or connected CPE IC 29-30
lre auto-retraining Initiates automatic retraining to find the
optimal transmission rate when the link to
a port is re-established GC 29-31
lre retraining Initiates the rate adaptation method to
find the optimal transmission rate based
on existing line conditions IC 29-32
lre rate-adaption Enables line rate adaptation which can set
the optimal transmission rate based on
existing line conditions GC/IC 29-33
lre apply Applies all global VDSL settings to each
port, overwriting any previous settings
configured for specific interfaces GC/IC 29-34
Table 29-2 Long-Reach Ethernet Commands (Continued)
Command Function Mode Page