SMC Networks TigerAccess SMC7816M - Manual (Page 722)

VDSL C
OMMANDS
29-40
ham-band
This command sets the Handheld Amateur Radio (HAM) band that will be
blocked to VDSL signals based on defined frequencies. Use the no form
to restore the default status.
Syntax
ham-band value
no ham-band
value – HAM band mask.
(See Table 29-4, “HAM Band Notches,” on page 29-7.)
Default Setting
22 (none)
Command Mode
VDSL Line Profile
Command Usage
Using a HAM band mask prevents interference with other systems (e.g.,
amateur radio) that use narrow band transmission in the VDSL
frequency band. The selected frequency range will not be used to
transmit data on the VDSL line. You may need to specify a mask if
required by local regulations or if specific incidents of interference are
reported within a service area.
Example
This example sets a HAM band notch in the transmitted power spectrum
in the 10.000 - 10.150 MHz transmission band (also called the 30 meter
band).
Related Commands
region-ham-band (29-41)
lre ham-band (29-7)
Console(config-line-profile)#ham-band 11
Console(config-line-profile)#