SMC Networks TigerAccess SMC7816M - Manual (Page 508)

S
YSTEM
M
ANAGEMENT
C
OMMANDS
20-48
SMTP Alert Commands
These commands configure SMTP event handling, and forwarding of alert
messages to the specified SMTP servers and email recipients.
logging sendmail host
This command specifies SMTP servers that will be sent alert messages.
Use the no form to remove an SMTP server.
Syntax
[no] logging sendmail host ip_address
ip_address - IP address of an SMTP server that will be sent alert
messages for event handling.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• You can specify up to three SMTP servers for event handing.
However, you must enter a separate command to specify each server.
Table 20-16 SMTP Alert Commands
Command Function Mode Page
logging sendmail host SMTP servers to receive alert messages GC 20-48
logging sendmail
level Severity threshold used to trigger alert
messages GC 20-49
logging sendmail
source-email Email address used for “From” field of
alert messages GC 20-50
logging sendmail
destination-email Email recipients of alert messages GC 20-50
logging sendmail Enables SMTP event handling GC 20-51
show logging
sendmail Displays SMTP event handler settings NE,
PE 20-52