SMC Networks TigerAccess SMC7816M - Manual (Page 474)

S
YSTEM
M
ANAGEMENT
C
OMMANDS
20-14
Default Setting
Normal operating mode
Command Mode
Global Configuration
Command Usage
Make sure that no dot1q-tunnel port is configured before exiting QinQ
mode (see “switchport mode dot1q-tunnel” on page 32-27). If there are
any dot1q-tunnel ports set on the switch, the no system mode
command will fail.
Example
Related Commands
show system mode (20-14)
show system mode
This command displays the switch system mode.
Command Mode
Privileged Exec
Command Usage
The system mode displays as QinQ or Normal mode.
Example
Related Commands
system mode (20-13)
Console(config)#system mode qinq
Console(config)#
Console(config)#system mode qinq
Console(config)#end
Console#show system mode
system mode:qinq
Console#