Dot1x max-req, Dot1x port-control, Dot1x max-req -36 dot1x port-control -36 – SMC Networks TigerAccess SMC7816M User Manual
Page 576: 36 dot1x max-req
U
SER
A
UTHENTICATION
C
OMMANDS
22-36
dot1x max-req
This command sets the maximum number of times the switch port will
retransmit an EAP request/identity packet to the client before it times out
the authentication session. Use the no form to restore the default.
Syntax
dot1x max-req count
no dot1x max-req
count – The maximum number of requests (Range: 1-10)
Default
2
Command Mode
Interface Configuration
Example
dot1x port-control
This command sets the dot1x mode on a port interface. Use the no form
to restore the default.
Syntax
dot1x port-control {auto | force-authorized | force-unauthorized}
no dot1x port-control
• auto – Requires a dot1x-aware connected client to be authorized by
the RADIUS server. Clients that are not dot1x-aware will be denied
access.
• force-authorized – Configures the port to grant access to all clients,
either dot1x-aware or otherwise.
• force-unauthorized – Configures the port to deny access to all
clients, either dot1x-aware or otherwise.
Console(config)#interface eth 1/2
Console(config-if)#dot1x max-req 2
Console(config-if)#