SMC Networks TigerAccess SMC7816M - Manual (Page 285)

C
ONFIGURING AN
A
LARM
P
ROFILE
10-33
• init-failure – Threshold for initialization failures that can occur within
any given 15 minutes. (Range: 0-900 seconds, where 0 disables the
threshold; Default: 1)
There are many factors which can cause an initialization failure,
including lossOfFraming, lossOfSignal, lossOfPower,
lossOfSignalQuality, lossOfLink, dataInitFailure, configInitFailure,
protocolInitFailure, or noPeerVtuPresent. All outstanding error
conditions associated with a VDSL transceiver are defined by the
vdslPhysCurrStatus bitmask in RFC 3728. However, note that since the
status of remote transceivers is obtained via the embedded operation
channel (EOC), this information may be unavailable for units that are
unreachable via the EOC during a line error condition. Therefore, not
all conditions may always be included in its current status.
This parameter sets the threshold for the number of initialization
failures within any 15 minute collection interval for performance data.
If the number of initialization failures in a particular 15-minute
collection interval reaches or exceeds this value, a
vdslInitFailureNotification notification will be generated. (Refer to RFC
3728 for information on this notification message.) No more than one
notification will be sent per interval.
• Alarm Profile Mapping – Applies an alarm profile to the selected
VDSL ports.